Pay Dues or become a Site Supporter |
|
General Discussion Sit down and chat with fellow members! Any topics that don't fit other categories goes here. |
|
Thread Tools |
#1
|
|||
|
|||
clutch problem
when engine is running cannot get into any gear. when engine is off can move shifter into gear. 1963 gmc 1500 305ci 4 speed manual
|
#2
|
||||
|
||||
Re: clutch problem
Do you have fluid in your reservoir?
__________________
Step by steps: To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts. To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts. To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts. Some people are like slinkys. Not worth much but funny as heck when pushed down stairs. __________________ If the women don't find you handsome, they should at least find you handy. |
#3
|
|||
|
|||
Re: clutch problem
yes, had been hearing rattling noise in first and reverse gears
|
#4
|
||||
|
||||
Re: clutch problem
Might be a worn first gear. First and reverse are the same if I remember right. It's VERY easy to drop the transmission on these and it's not overly heavy. You might hit up one of the parts guys in the marketplace for a new first gear then start pulling the tranny. I've got a full writeup, bolt by bolt, in my build thread here.
Even if you don't need that gear, it's good to have extras on hand for later. If you do need it, it should be there by the time you're ready for it.
__________________
Step by steps: To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts. To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts. To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts. Some people are like slinkys. Not worth much but funny as heck when pushed down stairs. __________________ If the women don't find you handsome, they should at least find you handy. |
#5
|
|||
|
|||
Re: clutch problem
thanks
|
#6
|
|||
|
|||
Re: clutch problem
Your clutch is not releasing fully. Check fluid, then have someone watch the linkage from below as you cycle the clutch (NOT running).
There is an adjustment for proper clearance (not too much, not too little) that may solve your problem. I doubt that the problem is in the tranny. I also wonder what technique Fetch uses to make tranny r&r easy. I have done mine twice over fifty years and would say it is hard to get to and VERY heavy. |
#7
|
||||
|
||||
Re: clutch problem
Quote:
Mine's a SM318 though, yours might be different.
__________________
Step by steps: To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts. To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts. To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts. Some people are like slinkys. Not worth much but funny as heck when pushed down stairs. __________________ If the women don't find you handsome, they should at least find you handy. |
#8
|
|||
|
|||
Re: clutch problem
Quote:
|
#9
|
||||
|
||||
Re: clutch problem
If you can believe the info on the internet, the three speed SM318 weighs about 65 pounds, and the four speed SM420 weighs about 135 pounds.
__________________
Ed Snyder Medford, Oregon 1962 1000 Pickup 401M & Muncie 318 with overdrive 1962 K1000 Suburban 401M & SM420 1967 CM1500 pickup 351E & NP435 |
#10
|
||||
|
||||
Re: clutch problem
Well there's your trouble! Your transmission is 70 lbs too heavy!
__________________
Step by steps: To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts. To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts. To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts. Some people are like slinkys. Not worth much but funny as heck when pushed down stairs. __________________ If the women don't find you handsome, they should at least find you handy. |
Bookmarks |
Thread Tools | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Problem with clutch disengaging | Clarke | Transmissions and Rear Ends | 36 | August 12th, 2022 02:15 AM |
FS- Late Mechanical clutch bell housing, flywheel and clutch | zigafomana | 1960-1966 GMC Marketplace | 11 | April 1st, 2014 01:26 AM |
6066gmc 60 model clutch problem | Archiver | Previous Forum Posts | 0 | July 4th, 2006 01:25 AM |
Re: have a problem | Archiver | Previous Forum Posts | 0 | December 3rd, 2003 12:24 AM |