Pay Dues or become a Site Supporter
|
Pay Dues or become a Site Supporter
|
|
|||||||
| General Discussion Sit down and chat with fellow members! Any topics that don't fit other categories goes here. |
 |
|
|
Thread Tools |
|
#1
November 4th, 2014, 10:15 PM
|
|||
|
|||
Easiest way to install gas grommet
Does anyone know the easiest way to install a gas grommet on the filler neck of a 1961 GMC pickup? Please help I already wrecked one.
|
|
#3
November 5th, 2014, 06:49 PM
|
||||
|
||||
|
Re: Easiest way to install gas grommet
Dielectric grease works great on this project. Remove gas cap and filler tube after loosening only the upper clamp on the rubber hose that connects the filler tube to the fuel tank. Be careful not to damage the filler tube as you try to break the seal between it and the hose and allow the loosened clamp to slip down the hose so it will be right there later when you need it. Clean exterior of filler tube. Install grommet and lube inside of grommet. Lube up the lower portion of filler tube and slide it in place while directing the lower portion into the hose that connects the filler tube to the fuel tank. Slide the loosened clamp in place and tighten. Reintall gas cap.
|
|
| Bookmarks |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Re: Windshield Gasket Install | Archiver | Previous Forum Posts | 0 | July 12th, 2008 01:32 AM |
| Re: Windshield Gasket Install | Archiver | Previous Forum Posts | 0 | July 12th, 2008 01:27 AM |
| 2 spd wiper install help? | Archiver | Previous Forum Posts | 0 | February 15th, 2005 12:25 AM |
| RE: [6066 GMC Truck] 305V6, Gas Guzzler? Would you install, or V8 ? | Archiver | Previous Forum Posts | 0 | May 29th, 2001 01:36 AM |
| 305V6, Gas Guzzler? Would you install, or V8? | Archiver | Previous Forum Posts | 0 | May 26th, 2001 01:52 AM |
