Pay Dues or become a Site Supporter
|
Pay Dues or become a Site Supporter
|
|
|||||||
| GMC V6 and V12 Engines Engine repair and rebuilding |
 |
|
|
Thread Tools |
|
#1
February 25th, 2020, 03:06 AM
|
||||
|
||||
What was the purpose of this set screw
I'm going to guess is was a a set screw to keep the engine from reving too high via have the throttle wide open? Could it have been a governor?
|
|
#3
February 25th, 2020, 05:46 PM
|
|||
|
|||
|
Re: What was the purpose of this set screw
I have never seen that particular bracket setup.
Is it an original part? Rod J Issaquah, WA
|
|
#4
February 26th, 2020, 01:45 PM
|
||||
|
||||
|
Re: What was the purpose of this set screw
Yes, it came with trucks that used the 4 so. Hydramatic. The longer pass. side part is where the original throttle linkage was connected at the top. The shorter one is where the hydramatic kickdown rod was connected.
|
|
#5
February 26th, 2020, 03:32 PM
|
||||
|
||||
|
Re: What was the purpose of this set screw
i have a bracket on my 61 chevy panel truck, it has a small block chevy. i need to look at it this spring, when i get it out. sometimes the throttle will stick when held wide open, it is binding at this bracket. any ideas?
|
|
| Bookmarks |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Screw dropped in cylinder | Archiver | Previous Forum Posts | 0 | May 30th, 2007 02:25 AM |
| Re:Screw dropped in cylinder | Archiver | Previous Forum Posts | 0 | May 29th, 2007 02:25 AM |
| Screw dropped in cylinder | Archiver | Previous Forum Posts | 0 | May 28th, 2007 02:57 AM |
| Re: [6066 GMC] Screw dropped in cylinder | Archiver | Previous Forum Posts | 0 | May 28th, 2007 02:27 AM |
| lock ring tools for sale and 1966 gmc screw jack | Archiver | Previous Forum Posts | 0 | March 28th, 2007 02:17 AM |
