Pay Dues or become a Site Supporter |
|
Transmissions and Rear Ends Three on the tree or four in the floor? Shift it all here. |
|
Thread Tools |
#1
|
|||
|
|||
slip yoke question
I have a 27 inch spline slip yoke. One of the spline is blind (not there).
My question pertains to ordering a new one. I contacted dennysdriveshafts.com and it seemed the salesman wasn't sure if I would be placing the right order based on what I was describing. My transmission is a 70's saginaw chevy 3 speed transmission bolted behind an inline six. The slip yoke looks exactly like a 1350 series Spicer yoke as pictured and described at dennys. The salesman thought it might take a 1330 series. He also mentioned that the looks may not be the same anymore. The prob I have is that the 1350 has a very distinct crescent carving at the bottom curve in the yoke. If I were grabbing one off the shelf, that's the one I'd pick. Here's the simpler question, do I have the correct yoke? The denny's ad says my yoke is for the Muncie line up M20, etc. I have a Saginaw. The current yoke slides in the tail of trans without a hitch (that I know of). I realize this is a left field question. Just hope a couple of you can respond. |
Bookmarks |
Thread Tools | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Slip yoke question on a T5 I am putting in, in place of the granny tranny. | Archiver | Previous Forum Posts | 1 | February 20th, 2011 01:16 AM |
Re: [6066 GMC] Limited slip and no slip on a 4x4 | Archiver | Previous Forum Posts | 0 | March 8th, 2005 01:17 PM |
Re: Limited slip and no slip on a 4x4 | Archiver | Previous Forum Posts | 0 | March 8th, 2005 12:53 AM |
RE: [6066 GMC] Limited slip and no slip on a 4x4 | Archiver | Previous Forum Posts | 0 | March 8th, 2005 12:06 AM |
Re: [6066 GMC] Limited slip and no slip on a 4x4 | Archiver | Previous Forum Posts | 0 | March 7th, 2005 12:00 AM |